However, it is also possible that the physical key is at fault. If you don’t get the proper click while pressing a key, some internal parts may be broken, or dust may have built up inside the key, preventing you from pressing it down properly. In such cases, you need to remove the key, check and repair any faults, and reinsert it. In this article, we have mentioned the full process along with everything you need to be careful about while following the process.
How to Fix Broken Keys on Laptop?
Most laptops come with membrane keyboards. So, we have listed the steps to fix broken keys while considering membrane laptop keyboards. They consist of a key cap, retainer clips to hold that key cap in place, and a rubber membrane that actually presses the switch below the key. However, mechanical keyboards on the laptop also include the retainer clip. Here, a spring replaces the rubber membrane. So, the majority of the steps you use to fix the keys are the same. Just make sure the spring is properly in place while reinserting the key. If there are any issues with the components of the keys, you might be able to replace only those components. However, some manufacturers do not sell individual components and instead opt to sell the whole keyboard. So, you need to replace your entire keyboard in such a scenario. Regardless, here is the step-by-step guide on how you can fix your broken keys on a laptop:
Remove the Key Cap
The first thing you need to do is to remove the key cap to be able to observe the inside of the key. Here’s how you can do so:
Check the Key’s Components
After you take the key cap off, follow the steps below to check and troubleshoot issues with the cap or the retainer clip:
Remove and Reinsert or Replace Retainer Clip
If you can’t push the clip down, you need to take it out and then put it back in. You also need to take it out before replacing it with a new one in case it’s broken. So, here are the steps you can apply to both take it out and put it back in as safely as possible:
Reinsert the Key
After troubleshooting the key, you can finish up by reinserting the key cap. If there were any issues with your cap, you could buy a new one and insert it in the same way.
